Is my damp subfloor groundwater or a leak?

We prove it with a meter test and pressure test. Both are common near the bay, and treating the wrong cause wastes money.

Why is there no wet patch even though I have a leak?

Sandy ground drains escaping water away immediately. That is why acoustic tracing rather than a visual search is the right tool here.

Do you check for corroded pipework while you are there?

Yes. Where salt corrosion has caused one pinhole, we inspect the surrounding runs and tell you what to expect next.

Can you find leaks under paving without lifting it all?

Yes, we mark the point and lift only what is needed, then reinstate the surface.

Do you provide written evidence for insurance?

Yes, including photos, the cause and post-repair pressure verification.

We are waiting for your call

Southern Sydney

Leak Detection in Southern Sydney

Near Botany Bay the ground itself makes leaks hard to find. Sandy soil around Rockdale, Brighton-Le-Sands, Sans Souci and Ramsgate drains escaping water away instantly, so an underground main can leak for months with no soft patch or puddle to give it away. A high water table makes matters worse, because damp subfloors and wet ground are normal here and easily blamed for a plumbing leak, or the other way round. Salt air corrodes exposed copper and fittings, producing slow pinhole leaks behind walls in older brick homes. Newer duplexes add in-slab pipework where a failure appears as a warm patch of floor. We meter test first to prove the loss, then locate it acoustically and thermally.

We Answer 24/7
Licensed & Insured
NSW Licence 317672C
Homes & Businesses
All of Greater Sydney

Call 0412 456 759 Get a Free Quote

Book leak detection in Southern Sydney

Send your details and we'll call you back to confirm a time.

We Answer 24/7
Licensed & Insured
NSW Licence 317672C
Homes & Businesses
All of Greater Sydney

How we handle leak detection in Southern Sydney

1. Isolate and pressure test

We shut off sections of the system and watch the meter and gauge. That confirms there really is a leak, tells us whether it is on the hot or cold side, and narrows it to a section of the property before anything is opened up.

2. Acoustic and thermal location

Acoustic equipment listens for the sound of water escaping under slabs and paving, while thermal imaging shows temperature patterns through floors and walls. Together they pinpoint the leak rather than leaving us to guess a metre either way.

3. Non-destructive access

Once the leak is marked, we open the smallest area that lets us reach it, whether that means a single tile, a small slab core or a neat wall access panel, instead of demolishing a bathroom to find one pipe.

4. Repair and verify

We repair the failed section, re-pressurise the system and re-check the meter with everything closed. You get a report showing where the leak was, what caused it and confirmation the system now holds pressure.

Every job is quoted on site and agreed in writing before work starts, so there are no surprises.

Suburbs we cover for leak detection in Southern Sydney

Rockdale Brighton-Le-Sands Arncliffe Bexley Sans Souci Ramsgate

Don't see your suburb? Call us, we cover the surrounding areas too.

Recent leak detection jobs in Southern Sydney

Invisible main leak, Ramsgate

A high bill with no wet ground in sandy soil. Meter testing confirmed constant loss, acoustic tracing located the split beside a garden path, and we exposed and repaired it in a single small excavation.

Subfloor moisture, Rockdale

A damp subfloor near the water table was assumed to be groundwater. Pressure testing proved a leaking cold line was contributing. We repaired it and the subfloor dried within days.

Wall pinhole, Bexley

A slowly spreading stain came from a salt-corroded copper line in an external wall. Thermal imaging pinpointed it, and we opened one small access, replaced the run and reinstated the plaster.